![]() ![]() I'd love to hear from someone more versed in how this actually functions. If the base had been in a different room, or if line of sight to the base were blocked, this may not have sorted itself out so neatly. I suspect while the robot was turning in circles looking for the dock in the old location, a sensor picked up a signal (likely optical?) from the base station in the new location, and thus was able to drive itself there. *A note on #6 above - I'm not sure how this would have worked out if I had changed the room that the base was in. That'll force it to firstly figure out its location, and then go on a quick hunt to find the new location of the charger. Tell the robot to go home / return to the dock. After the cleaning, the vacuum went directly to the new dock location, and everything appears updated in the map in the app. Put the robot anywhere in the room, but NOT on or even near the charger.I started a cleaning (a zone cleaning in this case, but I don't think that's relevant) and once it left the dock from the new location, the map in the app updated the dock location to the new location. ![]() An interesting quirk: on the map on the app, it showed the vacuum driving to the new location, but once it was docked, it showed the vacuum located at the old location.After a few minutes of looking in the wrong place, it suddenly turned around and drove straight to the new dock location, and docked itself.*.(It was kinda cute actually - us humans can anthropomorphize anything.) It drove back and forth and around in circles a bit, trying to find the dock.It began its little "wiggle dance" trying to dock itself, but soon figured out there was no dock there. Predictably, it drove back to the old dock location.But this time robot wont resume cleaning even it is fully charged and will always stay on dock. When battery is 20 again during cleaning, robot goes back to dock for charging. Use the app to tell the vacuum to return to dock. When battery is 80 again on dock, robot goes to the spot where it left to resume cleaning.It means users don’t need to switch the map manually when they move the robot to another level as the app does it for them. Furthermore, the Roborock S7 auto empty dock has an additional two layers of filtration. Move the base station to the new location. When Roborock unveiled the S5 Max, it changed the way we viewed 2-in-1 hybrids.Set a pin and tell the vacuum to "go here" so it was no longer on the base station.(I know the Eufy L70 has to start from scratch when this happens, so it was a nice surprise.) I was pleased to discover that the robot is able to update the location of its base station without resetting the map. I was concerned that I would have to wipe out the map of the entire house (along with room assignments, etc.) and start over. My wife and I rearranged the room that contains the base for our Roborock S4, resulting in my moving the base station from one wall of the room to another wall of the same room. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |